Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Repair Across Washington Park
If you’re in Washington Park and your fireplace is misbehaving, the cause is usually water, not fire. Most of the homes here were built in the postwar years without a chimney at all; the ones that have one are working with a small, older collection of brick and block chases plus the stucco-clad chases added during later renovations. Those assemblies take a specific kind of attention, and that’s the work we do.
We handle chimney repair in Washington Park from the firebox to the crown with one team. Our technicians have up to 12 years of experience, and they know that a smell of smoke in December, a seized damper in July, or a flue full of nesting material is rarely a burning problem. It’s months of subtropical damp doing quiet damage.
Call (877) 798-7859 to book a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Why Washington Park Homeowners Call Chimney Sweep Davie for Chimney Repair
The honest answer to “why us” in Washington Park is narrower than a sales pitch. We’re a chimney specialist, not a general handyman with a brush on the truck. Inspection, sweeping and repair are all handled by the same team, so nobody hands the diagnosis off to a second contractor who has to start over.
We work with established chimney product lines, including chimney repair materials from DuraFlex, HeatShield, Olympia Chimney, Gelco, Famco and Copperfield. That means a cracked clay flue gets matched to the right liner, not to whatever happens to be in the shop. It also means a HeatShield resurfacing is on the table when a full reline isn’t necessary, which is a repair method well beyond standard sweeping.
We know this neighborhood. Washington Park is unincorporated Broward County, and the housing stock tells you what you’ll find: 1950s through 1970s single-story concrete-block homes with stucco on the outside and asphalt shingle overhead. When we’re booked in Washington Park and the surrounding blocks, we know to look for a stucco chase instead of a brick stack, and to expect an attic crawl if the chase has no exterior cleanout.
Our technicians have up to 12 years of experience with exactly this kind of assembly. Ask us what we’ll be doing before we do it, and we’ll explain it in plain terms. Call (877) 798-7859 for a free estimate.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Chimney Cap Replacement in Washington Park
Chimney Cap Replacement in Washington Park is one of the two repairs we’re asked for most, and it’s where a lot of the water damage starts. A cap does two jobs: it keeps rain out of the flue and it stops birds, squirrels and insects from moving in. In the humid South Florida climate, a rusted or partly missing cap is a standing invitation for water to sit on the crown and work its way into the flue tile.
When a Washington Park homeowner needs cap replacement, the signs usually show up as a water stain on the ceiling near the chase, a chewed or blocked screen, or a flue full of nest material discovered on inspection. A typical cap replacement in Washington Park runs $250 to $600, depending on the flue size, the cap type and whether the crown needs minor repair at the same time. Famco caps and other established brands are what we work with.
What the job involves
We remove the old cap, check the crown and the top of the flue for cracks or spalling, and install a correctly sized cap fitted to the flue opening. If the crown is already failing, we’ll flag it before the new cap goes on. The written estimate sets the final price.
Signs you’re due for a new one
Rust streaks on the chase, a cap sitting crooked after wind-blown rain, or a screen that’s rusted through. If you’ve found bird or rodent nests in the flue, the cap is usually the reason. Call us to look before the next storm, not after.
Chimney Liner Installation in Washington Park
Chimney Liner Installation in Washington Park is what we recommend when a flue can’t do its job safely as it is. In the postwar chases we see here, the usual culprit is cracked or spalling clay flue tile, often from years of moisture and humid air rather than heavy burning. A damaged liner lets heat and carbon monoxide reach the structure around the flue.
When a Washington Park homeowner needs a liner, it’s usually because a sweep or inspection found cracked tile, a flue that’s too small for the appliance, or a chase with no working liner at all. A typical stainless liner installation in Washington Park runs $2,400 to $5,800, depending on flue length, liner diameter and whether the chase has an exterior cleanout. DuraFlex and Olympia Chimney systems are what we install. Where the tile is degraded but still serviceable, HeatShield resurfacing may be a lower-cost option; where the flue is badly broken, a full reline is the honest call.
Full reline versus resurfacing
HeatShield resurfacing smooths and seals a cracked but structurally intact flue. A flexible stainless liner, such as a DuraFlex system, provides new structural service for a deteriorated or missing flue. Which one applies is a camera-inspection question, not a preference.
Getting to the flue
Many Washington Park chases were built without an exterior cleanout, so the technician may have to reach the flue through a low-clearance 1950s attic. That access is slower and affects the quote. We’ll tell you upfront what the access involves.
Trusted Brands We Service in Washington Park
We work with established chimney industry product lines: Gelco, Olympia Chimney, Famco and Copperfield, along with DuraFlex and HeatShield for liners and flue resurfacing. These are the materials professionals use, and matching the component to your flue type matters more than reaching for the cheapest part available. We source the right component for the job and keep turnaround moving. We don’t stock parts on a truck or run a warehouse, so we won’t promise a same-hour fix; but we can get the correct part quickly once the inspection has shown what’s needed.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Repair Problems We See in Washington Park Homes
- Water entry at the chase penetration. Many roof and chase penetrations in Washington Park are flat-sealed with mastic or stucco instead of proper flashing, so hurricane-driven rain and humid air get in for months. That’s what rusts components and cracks the flue tile.
- Dormant flues and seized dampers. Fireplaces here sit dormant nine months out of the year. When a homeowner lights one for the first cold snap, the damper that moved fine two years ago now sticks, and the flue may have pests or a nest.
- Dense creosote on wood stoves assumed to be decorative. Wood stoves and rarely-used fireplaces can carry thick first- and second-degree creosote. Homeowners assume the fireplace is decorative and safe because it’s rarely used; the buildup is exactly why it isn’t.
- Chases with no exterior cleanout. When the only way to the flue is through a 1950s low-clearance attic, liner and damper work gets slower. The quote reflects it.
A typical Washington Park repair begins with a first-December call about smoke rolling back into the room. On inspection we often find spalling clay flue tile, a degraded crown, or a mastic-sealed penetration that’s been letting rain in all hurricane season. The fix usually lands on a cap, crown or flashing repair, a liner, or a HeatShield-resurfaced flue, plus guidance on burning dry wood so creosote stays first-degree.
Pricing for Chimney Repair in Washington Park, FL
What you’ll pay in Washington Park is set by the written estimate, not by a phone quote. Still, here are honest ranges so you can sanity-check a bid: cap replacement typically runs $250 to $600. Crown repair or rebuild typically runs $400 to $1,200. Flashing repair on a stucco chase runs $600 to $1,500. Tuckpointing runs $600 to $1,800 depending on square footage. Spalling brick repair runs $500 to $1,500. A rebuilt chase runs $3,500 to $9,000. Liner installation runs $2,400 to $5,800. What moves the number is access, whether the chase has a cleanout, and how much repair the camera inspection shows is actually needed.
Every estimate is free, and the written estimate sets the final price. We don’t guess at what a flue needs; we inspect, show you the evidence, and price the job from there. Call (877) 798-7859.
We Also Serve Cities Near Washington Park
We schedule chimney inspection, sweep and repair work in Washington Park and in the towns around it, including Boulevard Gardens, Franklin Park, Davie and Hollywood. If you’re on the edge of one of those and not sure you’re covered, call and we’ll confirm. The link below takes you to our general Washington Park area page for more detail. Call (877) 798-7859 to book.
Serving Washington Park, FL – Our Local Coverage Area
We serve Washington Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Chimney Repair in Washington Park
Yes, and especially here. In Washington Park, dormant fireplaces sit unused nine months of the year, so caps, crowns and dampers degrade and pests nest in the flue without the yearly burning that would show you something’s wrong. An inspection finds it before the first cold snap. Call (877) 798-7859 for a free estimate.
Smoke rolling back is usually a seized damper, a blocked flue, or a flue that can’t draw because of debris or a damaged liner. Here it’s often a nest or heavy creosote; occasionally the cap is part of the problem. A sweep and camera inspection will show exactly which. Call (877) 798-7859 and we’ll take a look.
Often, yes. A stucco-clad framed chase with a clay tile flue usually has a penetration sealed with mastic or stucco rather than proper flashing, so water works its way into the flue. Those chases tend to need flashing repair, crown work and possibly a liner more than they need heavy creosote removal. Call (877) 798-7859 for a free estimate.
You don’t, from the room, and that’s the point. Creosote looks harmless on a rare-use wood stove, but dense first- and second-degree buildup is what actually ignites. The only way to know is a visual sweep with the camera, and we’ll show you the evidence. Call (877) 798-7859.
Usually yes, but many Washington Park chases have no exterior cleanout, so we reach the flue through a low-clearance 1950s attic. That’s slower work and it affects the quote, and we’ll tell you before we start. Call (877) 798-7859 to schedule.
Written by the team at Chimney Sweep Davie.